Pressure Washers
UNPACKING
Remove the equipment and all parts from the carton. The carton should contain the following.
•One pressure washer (pump, engine, cart base)
•One cart handle assembly
•One detergent tank (PW2102) or gun/hose/lance wire hangers (PW2002)
•One spray gun
•One lance with nozzle (additional lance included in PW2102 model)
•One high pressure hose
•One pack of nuts, bolts, and manuals
•One bottle of engine oil
If any parts are missing, DO NOT RETURN THE UNIT TO THE RETAILER. Know the unit’s model number (located on the serial number tag on the pressure washer frame) and call 1-
After unpacking the product, inspect it carefully for any damage that may have occurred during transit. Make sure to tighten fittings and bolts before using the pressure washer.
Do not operate the unit if it’s damaged during shipping, handling, or use.
Damage could result in bursting and cause injury or property damage.
ASSEMBLY
Use two adjustable or 7/16” wrenches to assemble the pressure washer.
1.Slide the handle assembly over the lower legs of the cart base. Use the standard nut and bolt to secure the right rear leg. See Figure 1.
Figure 1 – Assemble Handle
2.a. For model PW2002: Attach wire holders to handle and frame as shown in figure 2 using a 3/8" or adjustable wrench.
b.For model PW2102: Attach detergent tank to backside of handle. Use the 4 hex bolts with flat washer under hex head and 4 nuts provided.
Figure 2 – Assemble Wire Hanger
Figure 3 – Wire hanger on base plate
3.a. Model PW2002: Slide clear plastic hose onto chemical injector hose barb (Figure 4). Use other end for detergent source.
Thermal | Chemical injector |
relief valve | hose barb |
Pump inlet |
|
High pressure hose
Brass swivel adapter | Pump | |
outlet | ||
| ||
Garden hose |
| |
|
| |
Figure 4 - Pump hook up |
|
b. Model PW2102: Slide clear plastic hose attached to leg onto plastic hose barb of detergent tank (see Figure 5).
www.chpower.com
4