75
Message List
When the printer cannot continue printing for some reason (an error status), the
printer beeps, the
indicator comes on, and an error message that
indicates the description of the error appears in the display. A Warning message
appears in the display when the printer requires some remedy (a warning status)
although the job is not affected.
If either of these messages appears, perform the following procedures according to
the message.
NOTE
•
When multiple warnings are occurring at the same time, the Waning messages appear
by rotation.
•
When the printer is in error status and warning status at the same time, the Waning
message does not appear.
•
For a message with the <Warning Message> mark, the printer does not stop the
operation even when the message is being displayed (when the printer is in a warning
status).
•
For a message with the <Auto Error Skip> mark, you can skip the error by pressing [
] and continue printing. However, part of the print data may be missing or it may
not be printed properly. When you want to stop the process, perform a soft reset to
eliminate the cause of the error, press [
], and then print again. Also, you can
automatically skip the errors to which this mark is attached by setting <
> in the
menu to <
>.
Message Cause and Remedy
Cause The temperature of the fixing unit exceeded a
fixed value after printing (especially paper with a
narrower width) continuously.
Remedy Please wait a moment. The printer cools down
the fixing unit automatically. It resumes the job
after finishing the cool down process.
(xxx indicates abbreviations
of paper sizes)
Cause Paper of the size specified in the application is
not loaded in the paper source (in all the paper
sources when < > is set to < >; in
the specified paper source when the setting is
fixed).
Remedy Refill or load paper.