8/6/2006
7
4.7 Mounting the camera in the housing:
Remove the lens cap and wrist strap. The pressure release plug should be pulled out
before inserting the camera. Attach the plastic slide tray to the camera’s tripod mounting
fixture with a coin, screwdriver or the end of the universal tool supplied (Fig. 5). Take care
not to excessively tighten the screw. Attach the zoom gear guide on the lens zoom bezel with
the mounting Velcro (Fig. 6), pointing the guide right into the slot of the gear ring on housing
bezel (Fig.7). Pull up the Mode Dial control button. Slide the camera into the body along the
guide rail and make sure the zoom gear guide coupled with the slot of the gear ring on the
lens bezel(Fig. 8). Make sure the camera body reach the limit and test the function of the
on/of button on the body of the housing. Slide the hot shoe plug into the hot shoe (Fig. 9)
Note: If you find that the buttons do not align properly with the controls , please check again
that the camera is properly seated to the limit of the guide rail.
(Fig. 5) (Fig. 6)
(Fig. 7) (Fig. 8)