Canon 5100 Appendix Lamp Replacement, Lamp Replacement Monitor Timer, Order Replacement Lamp

APPENDIX

LAMP REPLACEMENT

When the life of the Lamp of this projector draws to an end, the LAMP REPLACEMENT indicator lights yellow. When the image becomes dark or the color of the image becomes unnatural, replacement of the Lamp is required.

CAUTION

● For continued safety, replace with a lamp assembly of the same type.

● Allow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the projector can become very hot.

●Do not drop the lamp assembly or touch the glass bulb! The glass can shatter and may cause injury.

Follow these steps to replace the lamp assembly.

1	Turn off the projector and disconnect the AC plug. Allow the
	projector to cool for at least 45 minutes.
2	Cover.Remove the screw with a screwdriver and remove the Lamp
3	Remove the two screws with a screwdriver and pull out the
	Lamp Assembly by grasping the handle.
4	Replace the Lamp Assembly with a new one and tighten the two
	screws. Make sure that the Lamp Assembly is set properly.
	Replace the Lamp Cover and tighten the screw.
5	Connect the AC Power Cord to the projector and turn the
	projector on.
6	Reset the Lamp Replacement Monitor Timer (refer to the section
	“Lamp Replacement Monitor Timer” below).

NOTE : Do not reset the LAMP REPLACEMENT MONITOR TIMER when the lamp is not replaced.

LAMP ASSEMBLY

LAMP COVER

HANDLE

ORDER REPLACEMENT LAMP

Replacement Lamp can be ordered through your dealer. When ordering the Lamp, give the following information to the dealer.

● Model No. of your projector : LV-5100

●Replacement Lamp Type No. : LV-LP09

(610 285 2912)

LAMP REPLACEMENT MONITOR TIMER

Be sure to reset the Lamp Replacement Monitor Timer when the Lamp Assembly is replaced. When the Lamp Replacement Monitor Timer is reset, the LAMP REPLACEMENT indicator stops lighting.

1	Turn the projector on, and press the MENU button and the ON-SCREEN MENU will appear. Press the POINT
	LEFT/RIGHT buttons to select SETTING and press the SELECT button (refer to the page 32, 33). Another dialog box
	SETTING MENU will appear.
2	Press the POINT DOWN button and a red-arrow icon will appear. Move the arrow to “Lamp age,” and then press the
	SELECT button. The message "Lamp replace monitor Reset?" is displayed.
3	Select [Yes] to reset the Timer.

Do not reset the Lamp Replacement Monitor Timer, except after the lamp is replaced.

36