Trimming
You can cut out a portion of a recorded image and save it as a new image file.
Choose [Trimming].
zPress the nbutton to choose [Trimming] in the 1tab, then press the mbutton.
Choose an image.
zPress the qrbuttons or turn the 5dial to choose an image, then press the mbutton.
Trimming Area
Trimming Area Display
Recorded pixels after trimming
Adjust the trimming area.
XA frame will appear around the portion of the image to be trimmed.
XThe original image will display in the upper left and the trimmed image will display in
the lower right.
zMove the zoom lever to change the frame size.
zPress the opqr buttons to move the frame.
zPress the lbutton to change the frame orientation.
zIn an image with detected faces, gray frames appear around the faces located in the upper left image. The frames can be used for trimming. You can switch between frames by turning the 5dial.
zPress the mbutton.
Save as a new image and display.
zFollow Steps 4 and 5 on p. 129.
•Images recorded at a pixel setting of 
or 
(p. 55), or images resized
to 
(p. 129) cannot be edited.
•The width and height ratio of an image that can be trimmed is fixed at 4:3.
•The number of recorded pixels in a trimmed image will be smaller than before trimming.
•Movies cannot be edited.
130