Troubleshooting
If you have a problem with your camcorder, refer to this checklist. Consult your dealer
or a Canon Service Center if the problem persists.
Power SourceProblem | Cause | Solution |
|
|
|
| |||
|
|
|
|
|
Camcorder will not turn | Battery pack is exhausted. | Replace or charge the | 13 | |
on. |
| battery pack. |
|
|
| Battery pack is not correctly | Attach the battery pack | 13 | |
| attached. | correctly. |
|
|
|
|
|
|
|
The camcorder switches | Battery pack is exhausted. | Replace or charge the | 13 | |
off by itself. |
| battery pack. |
|
|
| Power save function has | Turn on the camcorder. | 25 | |
| been activated. |
|
|
|
Cassette compartment | Battery pack is exhausted. | Replace or charge the | 13 | |
will not open. |
| battery pack. |
|
|
| Cassette compartment cover | Open the cassette | 16 | |
| is not fully open. | compartment cover fully. |
|
|
Cassette compartment | Battery pack is exhausted. | Replace or charge the | 13 | |
stopped during loading/ |
| battery pack. |
|
|
unloading. | The camcorder | Consult a Canon Service | – | |
| ||||
| malfunctions. | Center. |
|
|
LCD/viewfinder switches | Battery pack is exhausted. | Replace or charge the | 13 | |
on and off. |
| battery pack. |
|
|
|
|
|
|
|
Battery pack will not | Battery packs will not | Charge the battery pack in | – | |
charge. | charge outside the | temperatures between 32 ºF |
|
|
| temperature range of 32 ˚F | and 104 ºF (0 ºC and 40 ºC). |
|
|
| and 104 ˚F (0 ˚C and 40˚C). |
|
|
|
| Battery packs become hot | Wait until the battery pack | – | |
| with use and may not | temperature is below 104 ˚F |
|
|
| charge. | (40 ˚C) and retry charging. |
|
|
| The battery pack is | Use a different battery pack. | – | |
| damaged. |
|
|
|
Buttons will not work. | Camcorder is not turned on. | Turn on the camcorder. | 24 |
| Cassette is not loaded. | Load a cassette. | 16 |
v flashes on the screen. | Cassette is not loaded. | Load a cassette. | 16 |
|
|
|
|
k flashes on the | Battery pack is exhausted. | Replace or charge the | 13 |
screen. |
| battery pack. |
|
h flashes on the screen. | Condensation is detected. | See reference page. | 144 |
“REMOVE THE | Camcorder stopped | Unload and reload the | 16 |
CASSETTE” appears on | operating to protect the | cassette. |
|
the screen. | tape. |
|
|
The wireless controller | Camcorder and wireless | Change the remote sensor | 77 |
will not work. | controller are not set to the | modes. |
|
| same remote sensor mode. |
|
|
| Batteries of the wireless | Replace the batteries. | 20 |
| controller are exhausted. |
|
|
148