Quick Start Function

When you close the LCD panel with the camcorder on, the camcorder enters the standby mode. In standby mode the camcorder consumes only about 1/3 the power used when recording, saving energy when you are using a battery pack. Additionally, when you open the LCD panel, the camcorder is ready to start recording in approximately

1 second*, allowing you to record the subject right away.

* The actual time required varies depending on the shooting conditions.

( 33)

1With the camcorder on and in a recording mode, close the LCD panel.

A beep will sound and the green ON/OFF (CHG) indicator will change to orange to indicate the camcorder entered standby mode.

2When you wish to resume recording, open the LCD panel.

The ON/OFF (CHG) indicator turns back green and the camcorder is ready to record.

IMPORTANT

Do not disconnect the power source during standby mode (while the ON/OFF ( HG) indicator is lit in orange).

NOTES

The camcorder will not enter standby mode if the LCD panel is closed while the A ESS indicator is on or flashing or while a menu is being displayed. The camcorder may also not enter standby mode if the LCD panel is closed while the memory card slot cover is open or when the battery charge is too low. Check that the ON/OFF (CHG) indicator changes to orange.

The camcorder will shut off if left in standby mode for 10 minutes,

regardless of the [Power Saving Mode] setting ( 149). Press POWER to turn on the camcorder.

You can select the length of time until shut-off or turn off the Quick Start

function altogether with the [Quick Start] setting ( 149).

Changing the position of the camera mode dial while the camcorder is in standby mode will reactivate the camcorder in the operating mode selected.

48 Š Video