170 Additional Information
Cannot record Cannot access the built-in memory
- There is a problem with the built-in memory. Save your recordings (0130) and initialize the
built-in memory using the [Complete Initialization] option (040). If the problem persists,
contact a Canon Service Center.
Cannot record Check the memory card
- There is a problem with the memory card. Save your recordings (0130) and initialize the
memory card using the [Complete Initialization] option (040). If the problem persists, use a
different memory card.
Cannot record movies in the built-in memory Initialize only using the camcorder
- The camcorder's built-in memory was initialized using a computer. Initialize the built-in mem-
ory with this camcorder (040).
Cannot record movies on this memory card
- Movies cannot be recorded on a 64 MB or smaller memory card. Use a recommended mem-
ory card (035).
Cannot record movies on this memory card Initialize only using the camcorder
- The memory card in the camcorder was initialized using a computer. Initialize the memory
card with this camcorder (040).
Cannot save the canvas
- Cannot save your [Pens and Stamps] drawings on the memory. Save your recordings
(0130) and initialize the memory (040).
Change the battery pack
- Battery pack is exhausted. Replace or charge the battery pack.
Check the memory card
- Cannot access the memory card. Check the memory card and make sure it is inserted cor-
rectly.
- A memory card error occurred. The camcorder cannot record or display the image. Try remov-
ing and reinserting the memory card, or use a different memory card.
- You inserted a MultiMedia Card (MMC) into the camcorder. Use a recommended memory card
(035).
- If after the message disappears, 4/7 appears in red, perform the following: Turn off the
camcorder and remove and reinsert the memory card. If 4/7 turns back to green you can
resume recording/playback. If the problem persists, save your recordings (0130) and ini-
tialize the memory card (040).
Do not disconnect the power source. Do not disconnect the USB cable unless you first use
the computer to safely end the connection.
- When the camcorder is in mode and is connected to the computer with the supplied
USB cable, the camcorder cannot be operated. Disconnecting the USB cable or power source
while this message appears may result in permanent loss of the recordings in the camcorder.
Use the computer's Safely Remove Hardware function to end the connection and disconnect
the USB cable before using the camcorder.