12
CONNECTING PROJECTOR
VIDEO IN
RGB IN
RESET
COMPUTER
AUDIO IN
AV AUDIO IN
AUDIO OUT
S–VIDEO IN
CONTROL
Y –– Pb / Cb –– Pr / Cr
ON
1
DIP
ON
OFF
23 4 5 6
13" MODE (640 x 480)
16" MODE (832 x 624)
19" MODE (1024 x 768)
OFFON ON
ON ON
ON ON
OFF OFF OFF
OFFOFF OFF OFF
OFF OFF OFF OFF
123456
OFF OFFON ONON ON21" MODE (1152 x 870)
CONNECTING TO COMPUTER
IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA)
VGA Cable Monitor OutputDesktop type Laptop type
Audio Speaker
(stereo)
Audio Amplifier
Control Cable
for Serial Port ✽
Audio Cable
(stereo) ✽
Terminal
Serial port PS/2 portAudio OutputAudio Input
CONTROL PORTAUDIO OUTCOMPUTER AUDIO INRGB IN ANALOGUse one of these Control
Cables or USB Cable
corresponding with the
terminal of your computer.
ADB portCables used for connection (✽= Cable or adapter is not supplied with this projector.)
Control Cable
for PS/2 Port ✽Control Cable
for ADB Port ✽
Audio
Cable ✽
(stereo)
NOTE :
When connecting the cable, the powercords of both the projector and the externalequipment should be disconnected fromAC outlet. Turn the projector andperipheral equipment on before thecomputer is switched on.USB portMAC Adapter ✽
Set slide switches
according to the
chart below.
• VGA Cable (HDB 15 pin)
• Control Cable for PS/2 Port ✽, Serial Port ✽, or ADB Port ✽
• USB Cable ✽
• MAC Adapter (When connecting to Macintosh computer) ✽
• Audio Cable (Mini Plug (stereo) x 1)✽
External Audio Equipment
Terminals
of the Projector
Terminal Terminal
USBSet switches as shown in the table
below depending on RESOLUTION
MODE that you want to use before
you turn on projector and computer.
◆MAC ADAPTER (Not supplied)USB
Cable ✽