Canon MV500i instruction manual Dubbing, Press Audio DUB

Dubbing

POWER

CAMERA

OFF

PLAY(VCR)

SEARCH

SELECT

ZERO SET	REW	PLAY	FF
MEMORY
AUDIO	– /	STOP	+ /
DUB.

PAUSE SLOW ⋅ 2

E

Do not connect/disconnect any cables to/from the camcorder when dubbing audio or preparing to dub audio.

PLAY (VCR)

1.Locate the point where you want to start audio dubbing, then press the PAUSE button.

•You can use the playback buttons on the body of the camcorder or the special playback functions on the wireless controller in the same way as in playback mode.

•The camcorder becomes set to playback pause mode.

2.Press AUDIO DUB.

•AUDIO DUB. and appear on the display.

3.Press the PAUSE button.

•Audio dubbing starts.

•Direct your voice into the microphone.

• changes to .

4.When you get to the point where you want to stop dubbing, press the STOP button.

•Audio dubbing stops and AUDIO DUB. disappears from the display.

•The camcorder returns to stop mode.

•You can also set zero set memory ( 75) at the place you want to stop audio dubbing, then every time you return to that position, audio dubbing will cancel.

•If instead of pressing STOP you press PAUSE, the camcorder will return to the playback pause mode.

Notes:

•You can not use the DV terminal while adding sound.

•You might want to adjust the audio mix ( 93) when playing back a tape with added sound.

•There may be a loss of sound quality if you add sound to a tape recorded on a camcorder other than the MV500.

•After adding sound 3 or more times to the same place on a tape, there may be some loss in sound quality.

Editing

89