Trimming

You can cut out a portion of a recorded image and save it as a new image file.

Trimming Area

Trimming Area Display

Recorded pixels after trimming

Choose [Trimming].

●Press the nbutton, choose the 1 tab and [Trimming], then press the m button.

Choose an image.

●Press the qrbuttons or turn the Êdial to choose the image and press the m button.

Adjust the trimming area.

XA frame will appear around the portion of the image to be trimmed.

XThe original image will display in the upper left and the trimmed image will display in the lower right.

●If you move the zoom lever to the left or right, you can change the frame size.

●If you press the opqr buttons, you can move the frame.

●If you press the l button, you can change the frame size.

●In an image with detected faces, gray frames appear around the faces located in the upper left image. The frames can be

used for trimming. You can switch between frames by turning the Êdial.

●Press the m button.

Save as a new image and display.

●Perform Steps 4 and 5 on p. 135.

• , , and images cannot be trimmed.

• The width and height ratio of an image that can be changed is fixed at 4:3 (for a vertical image 3:4).

•The number of recorded pixels in a trimmed image will be smaller than before trimming.

136