Turning on the Power
About Auto Power Off
To save battery power, the power will turn off automatically after 5 min. of idle use. To turn on the transmitter again, press the camera’s shutter button halfway, or press the test flash button (charge lamp).
About the Lock Function
By setting the power switch to <a>, you can disable flash’s button and dial operations. Use this to prevent the transmitter function settings from being accidentally changed after you set them.
If you operate a button or dial, <LOCKED> is displayed on the LCD panel (the functions displayed above function buttons 1 to 4, such as <=> and <@>, are not displayed).
About the LCD Panel Illumination
When a button or dial is operated, the LCD panel illuminates in green for 12 sec. When setting a function, the illumination continues until the setting is complete.
If the transmitter is the master unit in linked shooting, the LCD panel illuminates in green. If the transmitter is a slave unit, it illuminates in orange.
You cannot use the test flash while the camera’s 3/1/2timer is operating.
The transmitter settings are stored even when the power is turned off. To retain the settings when replacing the batteries, replace the batteries within 1 min. of turning off the power switch and removing the batteries. You can fire a test flash even when the power switch is set to the <a> position. Also, when a button or dial is operated, the LCD panel illuminates.
You can set a beep to sound when the slave unit is fully charged
Auto power off can be disabled
You can change the duration of the LCD panel illumination
14