Caravell Slimline | ENGLISH |
|
|
•Keep the cover open or remove the sliding covers and place them carefully on the floor.
•Remove the ice layer using plastic or wooden implements (never use metal implements).
•The
•Never use pointed or sharp implements.
•After
6 Maintenance
Please note the following in connection with cleaning of the freezer:
•Place the products from the freezer in a cold place or wrap them in insulating material.
•The cabinet should be switched off at the socket.
•Keep the cover open or remove the sliding covers and place them carefully on the floor.
The freezer can be cleaned with luke warm water and mild detergent. It should then be washed with clean water.
Never use detergents which contain chlorine.
Never use pointed or sharp implements.
Clean the cover in the same way as the cabinet. If the freezer is fitted with a condenser and associated fan at the bottom rear of cabinet, dirt and dust can collect on the cooling element. If cleaning is necessary, the power should be switched off, the cover removed and the cooling element
Remove the cover as follows. Remove all screws holding the cover in place and put to one side. Carefully draw the cover out as far as possible (taking care not to damage the thermostat’s sensor cable). It will now be possible to access the cooling element with the vacuum cleaner brush.
Be aware that the cooling element consists of sharp components and may be hot to touch.
After cleaning, refit the cover and insert and tighten all screws.
7 Troubleshooting
If you experience any problems with your freezer, please check the following before seeking assistance:
•Is the plug inserted?
•Is the socket switched on?
•Is the fuse in the meter cabinet intact?
•Has any fault current relay been disconnected?
•Has there been a complete power failure?
If the cabinet is very hot or air circulation is poor, you should provide the necessary circulation.
If the condenser is dirty, it should be
If you have checked the above and the freezer is still not working, call a service engineer.
State the type of fault and appliance, serial number and item no. (shown on the manufacturer’s plate on the back of the cabinet).
8 Disposal
The owner of the freezer is responsible for disposing of the freezer in a responsible way in accordance with the relevant legislation.
When a
Be aware of the rules for disposal. There may be special regulations which must be followed.
You can obtain information on disposal from:
•Your dealer
•The relevant authorities (municipal authority, environmental protection agency or other similar body)
•WEEE marking.
Handling of
9 Special considerations
The information in this user manual was correct at the time of printing.
Due to our programme of continuous product development, we must however reserve the right to make technical changes to the freezer models concerned. We will of course strive to continually update the user manual.
You should contact your dealer if you are in any doubt concerning the correct use of the freezer. They will be able to advise you on this.
The manufacturer accepts no liability for accidents or complications caused by the incorrect connection of the equipment.
10 Guarantee
Any guarantee will be void if the product has been misused!
This means used for purposes other than that originally intended, failure to follow the instructions in this manual and transport of the product not in its original packaging.
If changes are made to the freezer by unauthorised personnel, the manufacturer accepts no liability in connection with material damage and/or personal injury.
7
