1. Place the scala rider Q2 into Intercom Pairing mode following the
instructions in the PRIMARY BUDDY PAIRING section above.
2. Once the Red Light begins ashing rapidly, press and hold Volume
up for three seconds.
3. The Red and Blue Lights will ash ve times, conrming that the
Reset Pairing was successful.
STEP 3SET UP FOR MOBILE PHONE CALLS: PAIRING
If you have a Bluetooth enabled mobile phone and would like to
make and receive phone calls using the scala rider Q2, you must rst
pair your headset to the mobile phone.
NOTE: If you have a compatible Bluetooth GPS device you wish to
use with the scala rider Q2, please skip this step, and continue
ahead to STEP 4: SET UP FOR BLUETOOTH GPS DEVICE.
Pairing is a on e time pro cess. Once the headset is paired to a
specific mob ile phone during this Setup Proce dure, they will
remain paired a nd automati cally recog nize each ot her whenev er
they are withi n range. If the conne ction bet ween the phone and
headset is los t, tap the CTRL bu tton to re connect th e devices.
TO PAIR THE SCALA RIDER Q2 TO A BLUETOOTH MOBILE PHONE
1. Turn on your phone and make sure its Bluetooth function is
activated.
2. With the scala rider Q2 headset turned ON, press and hold
the CTRL Button for at least six seconds until the Red and Blue
Lights begin rapidly alternating.
3. Search for Bluetooth devices on your phone by following the
phone’s instructions. Please consult your phone’s User Manual
for more information.
4. After a few seconds the phone will list the scala-rider Q2
as a discovered device. Select it and follow your phone’s
instructions to accept the pairing.
5. When prompted enter 0000 (four zeros) as your PIN or passkey.
6. Your phone will conrm that pairing has succeeded and the
headset will begin ashing slowly in Blue.
NOTE: If the Pairing process is not completed within two minutes the
headset will return to Standby mode.
With some mobile phones, you may need to tap the CTRL button
to connect the headset to the phone after pairing is complete. The
scala rider Q2 headset will automatically connect to the last phone
connected to the headset.
STEP 4SET UP FOR BLUETOOTH GPS DEVICE: PAIRING
If you have a Bluetooth enabled GPS device and would like to transmit
navigation instructions and sounds from the GPS device through the
headset’s speakers, you must rst pair your headset to the GPS device.
NOTE: Not all Bluetooth enabled GPS devices allow connections to
Bluetooth headsets like the scala rider Q2. Please consult your GPS
device’s User Manual for more information.
TO PAIR THE SCALA RIDER Q2 TO A BLUETOOTH GPS DEVICE:
1. Turn on your GPS device.
2. With the scala rider Q2 headset turned ON, press and hold
the CTRL Button for at least six seconds until the Red and Blue
Lights begin rapidly alternating.
6scala rider® Q2™ MultiSet