Carrier KIT63000 installation instructions Installing the NEW Power Supply, Unit Operation Hazard

8: Remove the power supply module from the enhancement module by unscrewing the four Phillips head screws (Fig. 9).

You are now ready to install the new power supply.

INSTALLING THE NEW POWER SUPPLY:

1:Strip the red and black replacement power supply wires ¼” from ends.

2:Insert the high voltage wires through the holes in the enhancement face (Fig. 10-A). Make sure the wires do not kink or have twists in them.

3:Mount the new power supply module to the

enhancement module using the four screws removed earlier (Fig. 10-B).

NOTE: Make sure the green ground wire runs down the groove in the enhancement module face behind the power supply enclosure.

4: Reconnect the green ground wire to the enhancement module (Fig. 11).

5: Crimp the new ¼” quick disconnect terminal onto the red replacement power supply wire and connect to the ionization array (Fig. 12). This may require the use of needle-nose pliers.

CAUTION

UNIT OPERATION HAZARD

Failure to follow this caution may result in equipment damage or improper operation.

Improper wiring will reduce unit performance.

Fig. 11

Fig. 9

2 Screws

2 Screws

Fig. 10-B

Fig. 10-A

Fig. 12