Carrier KIT63000 installation instructions Removing the OLD Power Supply, CUT Hazard

REMOVING THE OLD POWER SUPPLY:

1:Turn off power to the heating and cooling system and to the InfinityTM air purifier.

2:Remove the air purifier door (Fig. 1). Disconnect the power cord and air flow sensor cables from the power supply module (Fig. 2).

3:Remove the filter and enhancement module from the air purifier cabinet (Fig. 3) and place on a flat surface in a well lit area.

Fig. 2

Fig. 1

CAUTION

CUT HAZARD

Failure to follow this caution may result in personal injury. Sheet metal parts may have sharp edges or burrs. Use care and wear appropriate protective clothing and gloves when handling parts.

Fig. 3

4: Disconnect the green ground wire from the enhancement module (Fig. 4).

5: Cut the two high voltage wires where they exit the power supply enclosure (Fig. 5).

Fig. 4

6:Disconnect the ¼” quick disconnect terminal (with the cut wire) from the ionization array and discard (Fig. 6) - this may require the use of needle-nose pliers.

7:Cut the splice away from the media enhancement grid wire (Fig. 7). Cut the media enhancement grid wire next to the wire splice under the heat shrink tubing (Fig. 8).

Fig. 6

Fig. 5

WARNING

ELECTRICAL SHOCK & HIGH VOLTAGE HAZARD

Failure to follow this warning could result in personal injury or death.

Before installing or servicing system, always turn off main power to system. There may be more than one (1) disconnect switch.

TO POWER SUPPLY

Fig. 7

TO ENHANCEMENT GRID

Fig. 8