Carrier KIT63000 installation instructions Catalog No. IIK63000-C01

6:Crimp the butt connector to the severed media cartridge enhancement grid wire (Fig. 13). Please note that the grid wires will typically be black.

7:Crimp the opposite side of the butt connector to the black replacement power supply wire (Fig. 14).

CAUTION

UNIT OPERATION HAZARD

Failure to follow this caution may result in equipment damage or improper operation.

Make sure the high voltage wire is routed behind the horizontal fiberglass rod.

Fig. 13 Fig. 14

CAUTION

UNIT OPERATION HAZARD

Failure to follow this caution may result in equipment damage or improper operation.

At this point it is critical that your hands are clean before applying the splice insulation tape around the butt connector. Dirt and/or oil can contaminate the insulation and cause the splice to fail.

8: Clean the butt connector and at least two (2) inches of the wires on either side with the alcohol swab (Fig. 15).

9: Remove the backing paper from the splice insulation tape and center on the butt connector along the length of the tape. Tightly wrap the insulation tape around the butt connector and wires (Fig. 16).

10: Tuck the completed splice behind the media cartridge enhancement
grid (Fig. 17).	Fig. 15
11: Insert the enhancement module back into the air purifier cabinet and
reconnect the power and air flow sensor cables.

12: Replace the door, turn the InfinityTM air purifier power switch to the on position, and turn on the power to the heating and cooling system.

Fig. 16

Fig. 17

Copyright Carrier Corp. • 7310 W. Morris St. • Indianapolis, IN 46231	Printed in China	Edition Date: 2/07	Catalog No. IIK63000-C01
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.			Replaces: New