Carrier Access 3104s quick start Basic Configuration, Setup Adit for access via Web-Browser

Quick Start

Basic Configuration

Basic Configuration

The following configuration is divided into logical sections, where each section configures an additional function. The first must be configured before the second and so forth, however, you may stop at any section and not add the following feature.

NOTE: The order in which commands are entered can affect the successful provisioning of the Adit 3104.

zSetup Adit for access via Web-Browser

zRestore Factory Defaults

zModify Default Admin User

zConfigure Ethernet WAN Interface

zConfigure Serial1 as WAN

zConfigure the Adit 3104 as a SIP Line Gateway

Setup Adit for access via Web-Browser

The following steps will configure the Adit 3104 to allow access to the Web Browser for configuration, through one of the 4 10/100Base-T LAN connections.

Note: for LAN access, no additional configuration is required to access the Adit using the web browser. To configure the WAN access:

1.Connect to the CLI via the DB-9 RS-232. See Setting up a CLI Connection on page 20.

2.Enable the remote admin WAN access with the following command sequence:

Command	Description
Username: admin	Log into the system (username and password).
Password: ********
Adit 3104> enable	Enter the Privileged mode.
Password: ********	Enter password for the Privileged mode.
#configure terminal	Enter the Configuration mode.
(config)# remote-admin web	Enable remote web admin.
primary-port enable

Adit 3104 - Release 1.6 23