Page 9 of 12 |
SIREN SWITCH
This momentary
It can optionally control Horn Ring Cycler 2 operation in the Standby positionSIREN if the HRC2 option is selected.
Horn - A simulated
The Siren
DIP | DIP | Siren |
with Rotary Selector Switch in Standby | ||
OFF | OFF | (Default) Produces Horn tone while pressed. |
ON | OFF | Manual control of Mechanical tone. |
|
| Also Mechanical tone continues to fall when Rotary Selector |
|
| Switch is changed from Mechanical Position. |
OFF | ON | Manual control of Wail tone. |
ON | ON | Activates Horn Ring Cycler 2 (HRC2) function. |
AUXILIARY INPUT
During installation an auxiliary input may be connected to the horn ring or other switching device. It provides the same operation as pressing the Siren
HORN RING CYCLER 2 (HRC2)
During installation, the auxiliary input must be connected and the HRC2 option selected. While the siren is in standby, tap the horn ring to bring the unit out of standby into Mechanical tone. Repeatedly tapping the horn ring will cycle through Mechanical, Wail, Yelp, and Phaser tones. Tapping the horn ring twice quickly will stop the siren tones and return the unit to standby. Press- ing and holding the horn ring will produce Horn tone until released. Then the siren will return to its previous siren tone or standby.
See OPTION SWITCHES section for further details.
RADIO VOLUME
The radio repeat volume level is set using an adjustment inside the case just behind the PA volume control. Press on the rear of the case to open the unit Set the Selector Switch to the Radio position and turn on the power. With the radio volume itself set to a normal level, set the siren radio volume adjust control to the desired level. Turn off power and press the unit back into the case.
RADIO ADJUST
CP5012A | 08/06/08 |