SERVICE
This unit is designed to provide years of reliable service under even the worst conditions. Many times there may appear to be a problem with the unit when the true problem is in the speaker, controlled devices, or improper installation. The following chart shows typical symptoms and possible causes.
A blown siren fuse doesn't necessarily mean that the unit is bad. If a speaker or speaker lead is shorted this fuse will blow before the unit is damaged. Disconnect the speaker leads and replace the fuse. If the OUTPUT light comes on with siren power on and Wail mode selected the amplifier is OK. Check the speaker or leads for possible shorting.
PROBLEMS
Symptom | Possible Cause | Check |
No power or siren | No power to enable input (org wire) | Does backlighting or POWER light come on? |
output | Bad speaker | Is the OUTPUT light on face coming on in Wail? |
| Connector(s) loose | Is an external fuse or circuit breaker used? |
| Rear panel fuse blown | Are the negative leads connected to a good ground? |
| Loose connection at power source |
|
No siren tones | Bad Speaker | Is the OUTPUT light on face coming on in Wail? |
| High Voltage Protection | Input voltage must be less than highest rated voltage. |
Distorted siren | Speaker assembly loose | Is the speaker bell or tip loose? |
sound | Intermittent Aux Input connection | Is the Aux Input used and wired properly? |
| Low vehicle voltage | Input voltage must be greater than lowest rated voltage. |
Intermittent siren | High Voltage Protection | Is the vehicle voltage regulator working properly? |
tone | Connector loose | Is the connector tight on the back of the unit? |
| Bad power connection | Is there a loose connection on a power lead? |
| Circuit breaker in supply connection | Is a circuit breaker used with at least a 50A rating? |
Horn function | Horn or Manual switch stuck | Does the horn or manual switch return when released? |
stuck on or | Aux Input improperly connected | Is the Aux Input used and wired properly? |
Manual stuck on | Aux Input Polarity Option set wrong | Is the AUX_P option properly configured? |
Wrong siren tone | Is the | |
| Tone disabled. | Check option switch settings. |
Some siren tones | Tone disabled | Check option switch settings. |
not working |
|
|
Light switches not | Loose output connections | Do the Light Control switch indicators light? |
working | Rear panel fuse blown | Is the corresponding fuse blown? |
RETURN
If you have any questions concerning this or any other Carson product, please contact our Technical Service Department at (888)
If a product must be returned for any reason, please contact our Technical Service Department to obtain a Returned Merchandise Authorization number (RMA#) before you ship the product to Carson. Please write the RMA# clearly on the package near the mailing label. Be sure to provide a return address, contact and phone number, along with a brief description of the problem.
TB0362A | Page 11 of 14 | 05/28/10 |