Cary Audio Design 7.125 owner manual Power Requirements, Cables, Interconnects, Introduction

INTRODUCTION

DO NOT place the Model 7.125 on a windowsill or any location exposed to direct sunlight.

DO NOT stack the Model 7.125 directly above heat-producing equipment such as another power amplifier.

Power Requirements

The Model 7.125 power amplifier is designed to operate from residential or commercial AC current mains. The voltage is 117/234 Volts AC @ 50/60 Hz.

Cables

The speaker cables from the output posts of the Model 7.125 power amplifier to the speaker system can be any length, as your speaker set-up requires. Select speaker cables of sufficient size to preserve the outstanding performance capabilities of your Model 7.125 power amplifier.

Heavy gauge #14 wire is suitable for distances up to 10 feet, #12 for 25 feet. Most audio dealers will have proper speaker cable in stock for this purpose. Consult your Authorized Cary Audio Design dealer for advice about wire.

Interconnects

Signal input connections are made via the input jack on the rear of the Model 7.125 power amplifier, either single-ended or balanced. The interconnect cables from the output of the processor can be any convenient length your installation set-up requires. The choice of a high quality interconnect cable is important. Once again, your audio dealer will have the proper cables in stock for this purpose.

WARNING - Do not touch the speaker output binding posts during normal operation. You may be shocked. Do not short-circuit the speaker output binding posts. Damage may occur or the fuse may blow. Do not parallel or “bridge” the speaker output binding posts as this will damage the amplifier.

8