Cary Audio Design 7.25 Source Component Connections & Output Settings, Protection Mode, Operation

OPERATION

SOURCE COMPONENT CONNECTIONS & OUTPUT SETTINGS

Make all connections before powering on the Model 7.250. It is also recommended that you power on the source components and processor in your system before powering on the Model 7.250. This avoids the possibility of any pops or transients from other components being amplified and sent to the speakers. Always start with a low volume level on the controller or preamplifier to avoid potential damage to the speakers. All volume and level adjustments are made on your preamplifier, controller or surround processor. When using the Model 7.250 for the first time, you should re-set the output levels of the channels on your processor.

PROTECTION MODE

The Model 7.250 is equipped to protect itself against potentially damaging conditions such as overheating, mis-wiring and electrical failures. Under such conditions, the Model 7.250 will enter a protection mode. When this occurs, the unit will mute to protect itself and speakers from potential damage. If the Model 7.250 enters protection mode (mutes itself):

1.Immediately power off the unit with the rear panel Master Power Switch and disconnect the AC power cord.

2.Examine all speaker connections to ensure there are no shorts.

Power on the Model 7.250. If the unit remains in a muted state, contact Cary Audio Design customer service for assistance.

13