Casablanca Fan Company 69xxD Hanging The Fan, Canopy Electrical Connections, PUll chain or

Step 3. To hang the fan body in the canopy, hold the fan body firmly and insert the ball into the canopy open- ing. Check that no wires were pinched. Rotate the fan body until the slot in the nylon ball fits into the pin opposite the canopy opening.

Note: Independent control of the light fixture using a W-80 requires an additional power wire run from the wall switch to the fan. See Page 10 for wiring.

HANGING THE FAN

CAPPED	ball
BLUE
D1-OPTION
WIRE ON
3-SPEED ONLY
FOR INDEPENDENT	slot	pin
W-80 LIGHT
CONTROL

NOTE: The fan weight is 36 pounds.

CANOPY ELECTRICAL CONNECTIONS

Step 4a. Attach the fan wires to the ceiling fixture outlet box wiring by twisting the bare ends of the wires together and then securing with a wire nut. Test that the connection is secure by pulling on the wire nut. Connect in this order:

Step 4b. Pull Chain or W-40 Wiring Connections

•GREEN leads from mounting plate and fan to GROUND conductor of power source. Secure with wire nut.

•WHITE wire from fan to white NEUTRAL wire in ceiling fixture outlet box. Secure with wire nut.

•BLUE wire and BLACK power wire from fan to BLACK power wire in ceiling outlet box. Secure with wire nut.

Step 4c. W-80 Wiring Connections

•GREEN leads from mounting plate and fan to GROUND conductor of power source. Secure with wire nut.

•WHITE wire from fan to white NEUTRAL wire in ceiling fixture outlet box. Secure with wire nut.

•BLACK power wire from fan to RED wire from W-80 in ceil- ing outlet box. Secure with wire nut.

•BLUE wire from fan to YELLOW wire from W-80 in ceiling outlet box. Secure with wire nut.

NOTE: See Page 10 for additional wiring information.

wire nut	PUll chain or
	w-40 connections

2 BLACK & BLUE

D1-OPTION WIRES

(WITHOUT W-80)

2 WHITE WIRES

3 GREEN WIRES

w-80 connections

blue & yellow

WIRES

black & red

WIRES 2 WHITE WIRES

3 GREEN WIRES

CANOPY HATCH INSTALLATION

Step 5. Tuck the wires into the canopy with the wire nuts pointed upwards, so that the WHITE and BLACK wires are on opposite sides of the canopy and all wires are clear of the canopy opening.

Step 6. Install canopy hatch with the last canopy screw and lock washer. To do this, tilt the fan body away from the hatch opening.

Tighten the screws firmly by hand only,

Step 7. Straighten the fan, then check to ensure that there is no movement be- tween the canopy and ceiling or Hang-Tru ball and top support shaft.

canopy

hatch

lock washer

canopy

screw

tilt the

fan to

install

last

canopy

screw

6