
Installation Procedures
For a new installation where you have received a new ONline System Concentrator and all the modules, the following steps must be performed prior to installing the EMM:
❑Install the concentrator in its location (rack, table, etc.) referring to the instructions in the ONline System Concentrator Installation and Operation Guide.
❑Remove blank panels on the concentrators to expose empty slots for the Controller Module, EMM, and ONline modules.
❑Install the Controller Module and ONline modules into the board guides at the top and bottom of the slots and slide them into the concentrator. Make sure the connectors are firmly seated in the backplane of the concentrator.
❑Fasten the
❑Plug the power cord into an outlet and verify that all modules come up in their default state. Optionally, press the LED Test button on the Controller Module to verify that all LEDs are functional.
Installing the EMM into an existing installation does not require you to power down the concentrator. The EMM, like all other ONline modules, has the ability to be “hot swapped,” meaning that you can install the module into any open slot and remove it with the concentrator in an operating state. Use the following procedure if you are installing the EMM into an existing installation.
1.Install the EMM into the board guides at the top and bottom of the empty slot and slide it into the concentrator as shown in Figure
Unpacking and Installing the Module 2 - 3