Use the REVERT command to restore the configuration values in effect at the time of the last save. Any unsaved changes made using the SET command are lost. The REVERT and SAVE commands support the same configuration groups as defined below.
❑Alert
❑All
❑Community
❑Concentrator
❑Device
❑Security
❑Module_Port
❑Terminal
❑TFTP
Configuring the Terminal
The terminal that attaches to the serial port on the EMM must be configured to the same parameter settings as the EMM so the terminal and EMM can communicate. These settings include baud rate, data bits, parity, and stop bits. Initially, the terminal settings must match the factory default settings of the EMM as specified in Table
3 - 4 ONline Ethernet Management Module Installation and Operation Guide
