3Com 5101M-MGT Quick Reference for Getting Started, Procedure Command

Quick Reference for Getting Started

Table 3-1 outlines the steps and commands necessary to configure your EMM. The procedures and command examples are explained further throughout this chapter. If you are familiar with these instructions, you may want to use this table as a checklist.

Table 3-1. Quick Reference for Getting Started

Procedure	Command
1. Configure your terminal to	Refer to your terminal vendor's
default	documentation
EMM communication settings
	SET TERMINAL HANGUP
❑ Configure EMM Terminal
	SET TERMINAL PROMPT
Settings	SET TERMINAL TIMEOUT
2. Configure the EMM
❑ Concentrator Configuration	SET CONCENTRATOR PLATFORM
	SET CLOCK
❑ Device Configuration (EMM)	SET DEVICE CONTACT
	SET DEVICE DIAGNOSTICS
	SET DEVICE LOCATION
	SET DEVICE NAME
	SET DEVICE PASSWORD
SNMP Configuration	SET COMMUNITY
	SET DEVICE DEFAULT_GATEWAY
	SET DEVICE IP_ADDRESS
	SET DEVICE SUBNET_MASK
	SET ALERT
	SET DEVICE TRAP_RECEIVE
	(Advanced EMM only)

3 - 2 ONline Ethernet Management Module Installation and Operation Guide