Rear and center speakers
Rear |
|
| Rear |
speaker | Center | Receiver | speaker |
(R) | speaker | (L) | |
|
| CENTER SPEAKER REAR SPEAKERS | |
} ] | }] |
| } ] |
|
| ||
|
| R | L |
Active woofer
Receiver | Active woofer |
SURROUND OUT | INPUT |
REAR |
|
CENTER |
|
WOOFER |
|
Note
Set the LOW FILTER switch to ON when you connect an active woofer. This cuts low frequency output from the front speakers so you can enjoy pure bass from the active woofer.
LOW FILTER
OFF ON
If you have an additional front speaker system
Connect them to the FRONT SPEAKERS B terminals.
If your TV monitor uses separate speakers
You can connect one of them to the SURROUND OUT CENTER terminal for use with Dolby Pro Logic Surround Sound (see page 18).
Selecting the impedance
Set the IMPEDANCE SELECTOR for the front speakers as indicated in the table below. Check the instruction manual of your speakers if you’re not sure of the impedance. (This information is usually printed on a label on the back of the speaker.)
if nominal impedance of | Set IMPEADANCE SELECTOR to |
your speaker is |
|
|
|
Between 4 and 8 ohms | 4 Ω |
|
|
8 ohms or higher | 8 Ω |
|
|
Getting Started
Selecting the speaker system
If you connect only one set of front speakers, set the SPEAKERS selector on the front panel to A. If you connect two sets of front speakers, see the following:
To drive | Set SPEAKERS selector to |
|
|
Speaker system A (connected | A |
to the FRONT SPEAKERS A |
|
terminals) |
|
|
|
Speaker system B (connected | B |
to the FRONT SPEAKERS B |
|
terminals) |
|
|
|
Both speaker systems A and | A+B* |
B (parallel connection) |
|
*Connect speakers with nominal impedances of 8 ohms, or higher, to the A and B terminals. You don’t have to switch the impedance selector, since it switches to 4 ohms automatically.
For even more powerful amplification
You can use the POWER SWAP function to connect two additional amplifiers.
1Unplug the power cord.
2Connect the rear speakers to the FRONT SPEAKERS terminals on this receiver.
The rear signals are output from the FRONT SPEAKERS terminals.
Rear speaker |
|
| Rear speaker |
(R) | Receiver | (L) | |
| FRONT SPEAKERS |
| |
R | B L | R A | L |
}] |
|
| } ] |
3Connect the first amplifier to the SURROUND OUT REAR, and connect the front speakers to this amplifier.
The front signals are output from the SURROUND OUT REAR terminals.
| Amplifier 1 |
Receiver | (for front speakers) |
SURROUND OUT | INPUT |
REAR |
|
CENTER |
|
WOOFER |
|
(continued)
7EN
