Note: You can perform an inband download (remotely or locally) when you are logged into an Advanced EMM. However, you cannot perform an inband download when you are remotely logged into either a Starter or Basic EMM. This is because Starter and Basic EMMs must be in maintenance mode in order to perform an inband download. When an EMM enters maintenance mode, a remote session is disconnected.

The following prerequisites must be completed prior to initializing the download:

You must have a TFTP server on the network to perform inband downloads

EMMs to be updated must be assigned to the same network as the TFTP server

Use the following procedure to perform an inband download to a Starter, Basic, or Advanced EMM. Additional steps required to perform a download from maintenance mode are included.

1.Transfer the contents of the UDK floppy disk to your network TFTP server using the copy command for DOS-based systems. Use the FTP BINARY mode for UNIX-based systems. Note that the FTP BINARY mode must be specified instead of the default ASCII mode or the file will be corrupted.

Note: If your TFTP server is running on a UNIX machine, you need to FTP the file from the DOS machine to the server. If your server is running in a DOS environment, you must be in the directory that contains the.BIN file when you start the server.

The floppy disk contains one file - emm400.bin, which updates the Flash EPROM.

5 - 16 ONline Ethernet Management Module Installation and Operation Guide

Page 94
Image 94
3Com 5101M-MGT installation and operation guide