![](/images/new-backgrounds/1114160/11416031x1.webp)
DC Control
CHANGING FREQUENCY SETTING
You will have to change the dip switch settings in the remote if you are using more than one fan in the same area and want to control them separately.
Step 1. At the circuit breaker or fusebox, turn the power off for the fan you want to change.
Step 2. Open the battery compartment door of the remote control and remove the battery.
Step 3. Change the dip switch settings, assuring that they are different from the previously installed fan(s).
Step 4.
Step 5. At the circuit breaker or fuse box, turn the power back on for the fan whose frequency you are changing.
Step 6. Within 60 seconds of restoring power, push and hold the SET button in the battery compartment for 5 seconds. The light will flash two times indicating completion of this step.
You should now have control of the fan. Step 7. Reinstall battery compartment door.
ON ECE
1 2 3 4
SET
BUTTON
D |
| ON |
|
|
| ON |
| ECE | SET |
|
|
|
| |
1 | 2 | 3 | 4 |
|
Note: You may want to label your controls to assure you do not mix them up.
OPERATION CFL MODE
Your fan has the ability to disable the dimming feature to allow the use of CFL bulbs.
To activate CFL mode:
1. Open the battery compartment door.
2. With the fan power off, move the toggle switch towards "D". 3. Replace the battery compartment door.
4. Press the power button again to restore power to the fan.
To cancel CFL mode:
5. Open the battery compartment door.
6. With the fan power off, move the toggle switch towards "ON". 7. Replace the battery compartment door.
D | ON |
D | ON |
ON | ECE | SET | ||
1 | 2 | 3 | 4 |
|
CONTROL HOLSTER INSTALLATION
Step 1. Locate a 2x4 wall stud in a convenient location.
Step 1. Orient the control bracket as shown over the 2x4 stud.
Step 1. Use the provided screws in the mounting holes. Install and tighten screws by hand only.
14