Part-1 QUICK START OPERATION

2. Loading Paper Roll And Replacing The Printer’s Ink Roll

Mode Switch

REGCAL X Z

OFF

RF

PGM

*Replace the printer cover by placing the cover’s front tab into the register’s groove.

*Load new paper following the instructions above, and re- place the printer cover.

1.To load journal paper

!Remove the printer cover by lifting up the back.

2. To remove journal paper

!Remove the printer cover fol- lowing the instructions above.

@Press the l key until ap- proximately 20cm of the pa- per is fed from the printer.

#Cut off the roll paper.

Default printer setting is for Journal.

To print receipts, please refer to 1-7-3 on page 24 to switch the printer for Receipt or Journal.

@Put a roll of journal paper into the holder.

#Cut the leading end of the roll paper with scissors and insert the paper into the inlet.

$Press the l key until 20 or 30 cm of paper is fed from the printer.

%Roll the paper onto the take- up reel a few turns.

^Set the left plate of the take- up reel and place the reel into the register.

$Remove the take-up reel from the printer and take off the left plate of the reel.

%Remove the journal paper from the take-up reel.

^Cut off the paper left in the printer and press the l key until the remaining paper is fed out from the printer.

&Remove the core of the pa- per.

◗To load receipt paper

!To use the printer to print re- ceipts, follow steps 1 through 4 of “To load journal paper”.

@Pass the leading end of the receipt paper through the printer cover’s paper outlet and replace the printer cover.

#Tear off any excess paper.

&Press the l key to take up any slack in the paper.

Options: Roll paper – P-5860 Ink Roll – IR-40

E

10