Operation Guide 5142
ENGLISH
Congratulations upon your selection of this CASIO watch.
ξ Note that the product illustrations in this manual are intended for reference only, and so the actual product may appear somewhat different than depicted by an illustration.
This watch does not have a city code that corresponds to the UTC offset of
Note that CASIO COMPUTER CO., LTD. assumes no responsibility for any damage or loss suffered by you or any third party arising through the use of this product or its malfunction.
About This Manual |
| Using the Crown |
In this manual, operations are performed using the watch’s crown, and the three buttons indicated by the letters A, Band C.
Hands and Indicators
zHour Hand x Second Hand c Minute Hand
v Mode Disk: Rotates to indicate the current mode and other information.
b Chronograph Signal n Day
This User’s Guide uses numbers shown above to identify watch hands and indicators.
The crown of this watch has a button part and a ring part. You can use the crown’s button and ring to perform a number of different crown operations.
Locking the Crown
To lock the crown, push down its ring part as far as it will go as you rotate the ring away from you until it is relatively tight. While the crown is locked correctly, the only crown operations possible are pressing the crown button and unlocking the crown.
Important!
ξPush down on the ring as you slowly rotate it. You should be able to feel it screwing securely into place.
ξYou should normally have the crown locked during normal daily use. Leaving the crown unlocked creates the risk of unintended operations or even damage due to impact.
ξNote that rotating the ring without pushing it down as far as it will go will change the settings of the watch. When locking the crown, be sure to press down firmly on the ring as you rotate it.
Unlocking the Crown
Rotate the ring part of the crown towards you until it loosens completely.
Crown ring
Pressing the Crown Button
You can press the crown button while the crown is locked.
Press
Pulling the Crown Out
After unlocking the crown, grasp the ring and pull the crown out.
Rotating the Crown
With the crown pulled out, grasp the ring and rotate the crown towards you to move the hands of the watch.
You can also perform
ξUse
|
|
With the crown pulled out, rotate it rapidly away from you two times.
After starting the
Rotate the crown towards you or press any button.
Note
ξYou can use
Pushing the Crown In
Carefully press the button of the crown the push the crown back in.
Important!
ξTo prevent unintentional operation, the button press operation of the crown becomes disabled automatically for about eight seconds after you push the crown back in. It will become
Note
ξIf you do not perform any operation for more than three minutes after pulling out the crown, crown operations will become disabled automatically. If this happens, push the crown back in and then pull it out again to
Disabling Crown Button Mode Switching
You can use the following operation to disable crown button mode switching. This helps to prevent accidental mode changes while wearing the watch.
To disable crown button mode switching
1.Hold down the crown button for at least two seconds until the watch beeps and then press A.
ξAt this time the x Second Hand will move to the 3 o’clock position.
2.Release both buttons.
ξThe watch will return to normal timekeeping.
ξWhile crown button mode switching is disabled, pressing the crown button will cause the x Second Hand to move to the 3 o’clock position. The x Second Hand will resume normal timekeeping when you release the crown button.
To
Hold down the crown button as you press A.