Casio AP-24 Deleting Memory Contents, Playback, To record to one track while playing, back from the other track, Using the Memory

										Using the Memory
	To record to one track while playing						2 Press the START/STOP button to start playback.
	back from the other track							• You can toggle the playback metronome sound on and
This procedure is basically the same as that under “To record									off by pressing the METRONOME button.
								• Playback stop automatically when the end of the tune
notes from the keyboard” on page E-16.
									is reached.
Example: To play back Track A while recording to Track B								• To stop part way through, press the START/STOP
									button.
1 Select the track you want to play back.								• To stop the metronome, press the METRONOME
									button.
		• While holding down the CONTROL button, press the
			RECORD button as many times as necessary so the				NOTE
			Track A indicator lamp is lit.
							•	You can change the playback tempo while playing back
2 Press the RECORD button to enter record standby.
								from memory.
		• This causes the Track A lamp to flash. While holding					•	You cannot change the tone when playing back from
								memory.
			down the CONTROL button, press the RECORD
			button so the Track B indicator lamp is flashing.
3 Start recording.							Deleting Memory Contents
		• Press the START/STOP button to start recording to
			Track B as Track A plays back. Play in time with the				IMPORTANT!
			playback from Track A.
							•	The delete operation cannot be undone. Make sure you
	MEMO							play back song memory contents and confirm that you
	• You can adjust the tempo and beat during record							no longer need it before performing the following
	standby. Playback, however, is performed using the							procedure.
	tempo and beat that was selected when Track A was
	selected.
							To delete the contents of a specific track
Playback							1 Enter record standby.
								• While holding down the CONTROL button, press the
Use the following procedure to play back from memory.									RECORD button. Each press of the RECORD button
									causes the indicator lamps to toggle between the two
									states shown below. Make sure that the indicator lamp
To playback from memory									for the track whose contents you want to delete is
									flashing.
1 Select the track(s) you want to play back.
		• While holding down the CONTROL button, press the							Track A		Track B
			RECORD button. Each press of the RECORD button						Indicator Lamp		Indicator Lamp
									Flashing		Flashing
			causes the indicator lamps to cycle between the three
			states shown below.
							2 Press the START/STOP button twice to delete the
				Track A	Track B	Both
								contents of the selected track.
			Indicator		Indicator	Indicator
			Lamp Lit		Lamp Lit	Lamp Lit
							To delete the contents of both tracks
		• A track whose indicator lamp is lit is in playback
							1 Hold down the RECORD button for at least two
			standby.
		• If you want to play back both tracks, both of the						seconds, until the indicator lamps of both tracks
			RECORD button’s indicator lamps should be lit.					start to flash.
								• This indicates that the contents of both tracks have
									been deleted.

420A-E-021A E-17