Figure 4
F
G
(Back)
B A
Figure 5
I C
5
GF
4I
I
6
2.Attach back panel C to the 4 brackets and crosspiece D. Note that the back panel C should be installed so it is in front of the 4 brackets (Figure 4). Use the two I screws, six F screws to secure the back panel in place (Figures 3 and 4). Note that you must also install the G clip at this time as shown in the illustration.
•First, install the topmost I screws on the left and right sides of the back panel C. Note that you should slip the G clip onto the F screw at point 5 before you screw in the F screw.
•The back panel C should rest on the feet of side uprights A and B as indicated by 6 in the illustration. Press the back panel C against crosspiece D while installing the I screws.
7
3.Rotate height adjustment screw 7 until it supports crosspiece D, preventing the crosspiece from bending when you press the pedals (Figure 5).
Important!
•Be sure to rotate adjustment screw 7 and perform the adjustment procedure described above before depressing the pedals. Failure to do so can result in damage to crosspiece D.