Assembly Instructions
CAUTION
•Take particular care to avoid injury when installing legs and pedals, and when mounting the keyboard onto the stand.
•When assembling, make sure that the sliding keyboard cover of the digital piano body is completely closed. If the cover is left open during assembly, it may close suddenly causing the fingers to be pinched between the digital piano body and cover.
Important!
•Be sure to assemble the stand on a flat surface.
•This stand does not include any of the tools required to assemble it. You should have a large Phillips head (+) screwdriver on hand for assembly.
Figure 1
|
| x4 | E |
A | C | x6 | F |
| x1 | G | |
|
| ||
| B | x2 | H |
| x2 | I | |
|
|
D
•Check the items that come with the unit to make sure that everything shown in Figure 1 (A through I) is included. All screws are in a plastic bag inside of the packing cardboard.
Figure 2
1
1Assembling the stand
Refer to Figures 3, 4 and 5 as you assemble the stand according to the following procedure.
Figure 3
E
I
C 
E I
A 
D I
E
Side upright
3
B
Set upright
2
1.Attach side uprights A and B to crosspiece D using the four E screws (Figure 3).
•When joining the two pieces marked 2, the metal pieces 3 on the insides of side uprights A and B should fit into the slots at the ends of crosspiece D. Make sure the metal pieces are pushed into the slots as far as they will go. If they are not, the metal pieces 3 and the screws E will not match up correctly, which can cause stripping of the screws.
•Before starting actual assembly of the stand, undo the clip at location 1 (Figure 2) where the pedal cable comes out the back of crosspiece D.