Using Built-in Tones

Adjusting the Brilliance of a Tone

1. Press the cs (FUNCTION) button.

The FUNCTION lamp will light and the function screen will appear on the display.

Lit

2. Use the do (i) and dn (u) buttons to select the Tmpr/Effect screen.

3. Press the dp (ENTER) button.

This will display a screen for selecting settings in the Tmpr/Effect group.

4. Use the do (i) or dn (u) button to select the brilliance screen shown below.

5. Use the ct (w, q) buttons to adjust the brilliance of the currently selected tone. You can adjust brilliance in the range of –3 to 0 to 3.

w: Mellower and softer

q: Brighter and harder

6.Press the cs (FUNCTION) button.

This will exit the brilliance screen and cause the FUNCTION lamp to go out.

NOTE

•See “Other Settings” (page E-41) for details about using the cs (FUNCTION) button.

Adding Reverb to the Tone

1. While holding down the cs (FUNCTION) button, press the dk (REVERB) button.

This will display a reverb type selection screen.

2. Use the ct (w, q) buttons to select the reverb type you want.

•The following shows the five available reverb type settings.

0:OFF (no reverb)

1:Room

2:Hall

3:Large Hall

4:Stadium

3.Press the cs (FUNCTION) button.

This exits the reverb type selection screen.

English

E-9