Assembly Instructions

Figure 4

B

A

2 Installing the Keyboard onto

 

 

(Back)

the Stand

F

 

C

 

 

G

 

 

CAUTION

I

 

 

Take care that you do not pinch your fingers between the

 

 

keyboard and stand!

 

 

 

5

Figure 6

GF

4I

I

8

8

 

H

6

 

2. Attach back panel C to the 4 brackets and crosspiece D.

H

Note that the back panel C should be installed so it is in

 

front of the 4 brackets (Figure 4). Use the two I screws,

 

six F screws to secure the back panel in place (Figures 3

 

and 4). Note that you must also install the G clip at this

Be sure that you securely anchor the keyboard to the stand

time as shown in the illustration.

using the H butterfly bolts (Figure 6).

• First, install the topmost I screws on the left and right

• Slide the screws on the bottom of the keyboard into the

sides of the back panel C. Note that you should slip the

slots in the two angle brackets 8. Next, secure the keyboard

G clip onto the F screw at point 5 before you screw in

to the stand with two butterfly bolts H (Figure 7).

the F screw.

 

• The back panel Cshould rest on the feet of side uprights

Figure 7

Aand B as indicated by 6 in the illustration. Press the back panel C against crosspiece D while installing the

I screws.

8

Back

H

Figure 5

Front

• The butterfly bolts keep the keyboard from falling from the stand. Be sure that you always secure the keyboard with the butterfly bolts.

7

3.Rotate height adjustment screw 7 until it supports crosspiece D, preventing the crosspiece from bending when you press the pedals (Figure 5).

Important!

•Be sure to rotate adjustment screw 7 and perform the adjustment procedure described above before depressing the pedals. Failure to do so can result in damage to crosspiece D.

430A-E-039A

E-37