Problem

Possible Cause and Recommended Action

 

Language selection

1)You did not configure initial settings after purchasing the

 

screen appears

camera or the camera may have been left with a dead

 

when the camera is

battery. Configure the correct settings (pages 19, 166).

 

turned on.

2)There may be a problem with the camera’s memory data. If

 

 

this is the case, perform the reset operation to initialize the

 

 

camera’s setup (page 170). After that, configure each setting.

 

 

If the language selection screen does not re-appear when you

 

 

turn the camera on, it means that the camera’s memory

 

 

management data has been restored.

 

 

If the same message appears after you turn power back on,

 

 

contact your retailer or a CASIO authorized service center.

 

 

 

 

The time and date

Load the camera’s battery and reconfigure the time and date

 

settings configured

settings (page 19). Do not remove the battery from the camera

 

the first time after

for at least 24 hours after configuring time and date settings.

 

purchasing the

After that, the settings will not be reset if you remove the

 

camera are reset to

battery.

 

their factory

• If the time and date are reset to their factory default settings

 

defaults when I

when you remove the battery after it has been loaded for

 

remove the

more than 24 hours, it could mean that the camera’s setting

 

camera’s battery.

memory is defective. Contact your retailer or a CASIO

 

 

authorized service center.

 

Buttons are not

With large capacity memory cards there is a delay after the

 

responsive right

power has been turned on before the buttons become

 

after the power has

responsive.

 

been turned on.

 

 

 

 

Display Messages

 

The camera’s protection function may have activated

ALERT

because camera temperature is too high. Turn off the

camera and wait until it cools down before trying to use it

 

 

again.

Battery is low.

Battery power is low.

Camera not in

The camera could not go into auto record standby for some

reason during a Move Out CS or Move In CS operation.

standby.

Compose the image again with the boundary aligned

Re-frame the image.

correctly (page 81).

 

The image you specified with the slideshow “Images”

Cannot find the file.

setting cannot be found. Change the “Images” setting (page

 

120) and try again.

Cannot register any

You are attempting to save a user BEST SHOT scene in

the “SCENE” folder when the folder already contains 999

more files.

user scenes.

 

 

 

B

191

Appendix