PLAYBACK

To re-record audio

1.In the PLAY mode, rock the controller left or right to scroll through snapshots until the one whose audio you want to re-record is dis- played.

2.Select the “PLAY” tab, select “Dubbing”, and then rock the controller to the right.

3.Rock the controller up or down to select “Delete”, and then click.

•If you merely want to delete the audio with re-record- ing, press MENU here to complete the procedure.

4.Press the shutter release button to start audio recording.

5.Recording stops after about 30 seconds or when you press the shutter release button.

•This deletes the previous recording and replaces it with a new one.

IMPORTANT!

•Keep the microphone on the front of the camera pointed at

the subject.

• Take care that you do not block the microphone with your fingers.

Microphone

•Good recording results are not possible when the camera is too far from the subject

•Operating camera buttons during recording can cause button noise to be included in the audio.

•The (Audio) icon appears on the monitor screen after audio recording is complete.

•You will not be able to record audio when remaining memory capacity is low.

•The following types of audio recording are not sup- ported.

—Adding audio to a movie image

—Adding audio to a protected snapshot (page 64)

•Audio that is re-recorded or deleted cannot be recov- ered. Make sure you no longer need audio before re- recording or deleting it.

59