High Speed CS Shooting Using the Mechanical Shutter Only (F CS)

Due to the characteristics of the CMOS imaging element, shooting fast-moving subjects with High Speed CS may cause the subject to become distorted. If this happens, try shooting with F CS (Full pixels Continuous Shutter), which uses the mechanical shutter only and eliminates the problems caused by the CMOS imaging element characteristics. Note that the following settings are available when shooting with F CS.

CS Speed (frames per second): 3 fps, 5 fps, 10 fps

Maximum Number of Shots: 5, 10, 20, 30

Also, note that F CS does not support Prerecord CS.

.Getting Ready

1.Set the mode dial to t (Auto).

2.In the REC mode, press [MENU].

3.Use [4] and [6] to select the “REC” tab.

4.Use [8] and [2] to select “CS” and then press [6].

5.Use [8] and [2] to select “F CS”, and then press [SET].

6.Press Õ (Continuous Shutter).

•This will display á (F CS). If this does not happen, press Õ again.

7.Press [SET].

8.Use [8] and [2] to select the fourth control panel option from the bottom (F CS fps).

9.Use [4] and [6] to select the continuous shutter (CS) speed you want. Enables specification of the number of CS images recorded per second.

10.Use [8] and [2] to select the third control panel option from the bottom (Max CS shots).

11.Use [4] and [6] to select the maximum number of shots for each continuous shutter operation.

12.Press [SET].

53

Snapshot Tutorial