GETTING READY

NOTE

•The AC adaptor is designed for operation on power ranging from 100V AC to 240V AC. Note, however, that the shape of the power cord plug varies according to country or geographic area. It is up to you to find out if the shape of the AC adaptor power cord plug is compatible with local power outlets when traveling abroad.

2.Turn off the camera.

IMPORTANT!

• It takes about two hours to achieve a full charge.

Actual charging time depends on current battery

capacity and charging conditions.

• Use only the USB cradle (CA-22) or the optionally

available charger unit (BC-10L) to charge the special

NP-20 rechargeable lithium ion battery. Never use

any other charging device.

• Use only the bundled AC adaptor. Never use any

other type of AC adaptor. Do not use optionally

available AD-C40, AD-C620 and AD-C630 AC

adaptors with this camera.

3.Set the camera onto the USB cradle.

•Do not place the camera onto the USB cradle while it is turned on.

•The [CHARGE] lamp on the USB cradle should turn red, indicating that charging has started. When charging is complete, the [CHARGE] lamp will turn green.

MENU

PLAY

REC

DISP

SET

PHOTO

 

CHARGE

USB

 

[CHARGE] lamp

• Make sure that the camera connector of the USB

cradle is securely inserted into the camera’s

connector as far as it will go.

• The [CHARGE] lamp may remain amber colored and

the charge operation may not start right away if you

try to charge immediately after using the camera

(which causes battery to become warm) or when it is

too hot or too cold where you are performing the

charge operation. If this happens, simply wait until

the battery reaches normal temperature. The

[CHARGE] lamp will turn red and charging will start

when the battery temperature returns to the

allowable charging temperature range.

4.After charging is complete, remove the camera from the USB cradle.

27