To load the batteries
Caution
•Do not touch the springs inside the battery compartment cover with your fingers while loading or replacing batteries. The springs have sharp areas and can cut your fingers.
1.Turn power off.
2.Turn over the label printer and remove the back cover while pressing down on its lock as shown in the illustration.
3.Load batteries into the battery compartment.
• Be sure to use alkaline batteries.
• Make sure the positive (+) and negative
4.Replace the back cover.
•Make sure the back cover is positioned as shown in the illustration when replacing it.Trying to force the cover into place while it is in the wrong position can cause damage to the cover or label printer.
•Make sure that the tape cartridge is securely in place and that the back cover is closed securely before using the label printer. A loose tape cartridge can cause print quality problems.
Turning Power On and Off
Press ON/OFF to turn power on and off.
Power On | Power Off |
W I D T H O F T A P E ? |
|
➔ |
|
1 8 mm
1 2 mm
• Turn on power, and the tape width selection screen will appear. When selecting the tape width, be sure to select the setting that is the same as the actual width of the tape you are using. Selecting the wrong tape width will result in abnormal printing.
Important!
•If you are using the Label Printer for the first time, you should reset it first.
Resetting the Memory
You should reset the memory of the Label Printer before using it for the first time, after you have not used it for a long time, or if nothing happens when you turn power on, even after you change the batteries.
Important!
•Resetting Label Printer memory clears its memory of all input data.
To reset the memory
1.Make sure that Label Printer power is off.
2.While holding down the PRINT and SPACE keys, press ON/OFF to turn power on.
•This prompt confirms whether or not you want to initialize the Label Printer.
I N I T I A L I Z E ?
S E T / E S C