Casio KL-780 Error Messages/Display Messages, • Tape Cutting, •Using Labels, SET, ESC, Page, Page, Page, Page, E-23, Action, Action, Action, Action, Action, Message

Ink ribbon is being fed from the tape outlet along with the tape.
Possible Causes	Action	Page
Tape cartridge loaded	Remove the tape cartridge and check
while the ink ribbon is	to make sure the ink ribbon is not
slack.	broken. Next, take up any slack in the
	ink ribbon and then reload the tape
	cartridge.

	Important!	E-8
	• Before loading a tape cartridge into
	the label printer, always make sure
	you take up any slack in the ink
	ribbon first.
	• If the ink ribbon is broken, you
	must change to another tape
	cartridge.
• Tape Cutting
	Cannot cut tape.
Possible Causes	Action	Page
Tape cutter blade is dull.	Take the label printer to the dealer
	from whom you purchased it to have	—
	the tape cutter blade replaced.
Printed text is cut off by tape cut operation.
Possible Causes	Action	Page
Out of tape	Replace the tape cartridge with a new	E-8
	one.

•Using Labels

Label will not adhere to a surface.

Possible Causes	Action	Page
The backing paper is still	Peel the backing paper from the back	E-16
on the back of the tape.	of the tape to expose the adhesive.
Surface is unsuitable for	Labels do not adhere well to surfaces	E-16
affixing a tape.	that are rough, wet, oily, or dirty.

Error Messages/Display Messages

Message	Possible Causes	Action
¥ ERROR!	• The number carriage	• Use wider tape or reduce
	returns you input causes	the number of lines.
* This message
	the label to exceed the	6mm tape...1 line
appears on the	maximum number of lines	9mm tape...1 line
screen for about	for the tape you are	12mm tape...Up to 2 lines
one second.	using.	18mm tape...Up to 3 lines
	• You are attempting to	• Reduce the number of
	print a stamp while three	lines of text to two.
	lines of text are input.
NO DATA!	• You are attempting to
	recall text from memory
* This message
	when there is none
appears on the	stored.
screen for about
one second.
OVERWRITE?	• You are attempting to	• Press SET to overwrite
SET/ESC	store text in memory	the existing text with the
	when it already containes	new text, or ESC to
	text.	cancel the store
		operation.

E-23