
Tape comes out when PRINT is pressed, but nothing is printed on it.
Possible Cause | Action |
Only blank spaces | Input the text you want to print. |
were input. |
|
|
|
| |
Printing is blurred, blotched, broken, etc. | |
Possible Cause | Action |
|
|
Improper print density | Adjust the print density setting. |
setting |
|
|
|
Improper loading of | Remove the tape cartridge and |
the cartridge | reload it correctly. |
|
|
Dirty print head or rub- | Clean the printer head and |
ber roller | roller. |
|
|
Ink ribbon is being fed from the tape outlet along with the tape.
Possible Cause | Action |
Ink ribbon cassette | Remove the ink ribbon cassette |
loaded while the ink | and check to make sure the ink |
ribbon is slack. | ribbon is not broken. Next, take |
| up any slack in the ink ribbon |
| and then reload the tape car- |
| tridge. |
Important!
•Before loading an ink ribbon cassette into the label printer, always make sure you take up any slack in the ink ribbon first.
•If the ink ribbon is broken, you must change to another ink ribbon cassette.
•Tape Cutting
Cannot cut tape.
Possible Cause | Action |
|
|
Tape cutter blade is | Take the label printer to the |
dull. | dealer from whom you pur- |
| chased it to have the tape cut- |
| ter blade replaced. |
|
|
| |
Printed text is cut off by tape cut operation. | |
Possible Cause | Action |
|
|
The printer is set up | Be sure to press the FEED key |
for manual tape feed. | before performing the tape cut |
| operation. |
| Important! |
| When the printer is set up for |
| manual tape feed, the tape is |
| not fed automatically after print- |
| ing is complete. |
|
|
Out of tape | Replace the tape cartridge with |
| a new one. |
|
|
•Using Labels
Label will not adhere to a surface.
Possible Cause | Action |
|
|
The backing paper is | Peel the backing paper from the |
still on the back of the | back of the tape to expose the |
tape. | adhesive. |
|
|
Surface is unsuitable | Labels do not adhere well to |
for affixing a tape. | surfaces that are rough, wet, |
| oily, or dirty. |
|
|
•Data Communication
Cannot transfer data.
Possible Cause | Action |
|
|
Poor data communi- | Make sure the data communi- |
cation cable connec- | cation cable jacks are con- |
tion | nected securely. |
|
|
Passage of too much | Be sure to start actual data |
time after setting up | transfer within about 20 seconds |
for data communica- | after pressing SET to start a data |
tion | communication operation. |
|
|