Using Registration Memory
To store a setup in registration memory

1 On the digital piano, configure the tone, rhythm, and other settings you want to save as your setup.

•See “Registration Memory Setup Data” (page E-18) for more information.

2 Use the BANK button to select the registration memory bank where you want to save the setup.

•This causes the number of the selected bank to appear on the display for about two seconds. If you do not perform the following step within that time, the bank selection screen will disappear.

Example: Bank 1 selected

WARNING

•The following step will replace the setup currently in the area you select with the new setup. Make sure you do not need the current setup before performing the next step.

To recall a setup from registration memory

1 Use the BANK button to select the registration memory bank that contains the setup you want to recall.

•This causes the number of the selected bank to appear on the display for about two seconds. If you do not perform the following step within that time, the bank selection screen will disappear.

2 Press the REGISTRATION button (1 to 4) for the area that contains setup you want to recall.

NOTE

•If you press a REGISTRATION button without selecting a bank first, the digital piano will recall the setup from the applicable area in the bank you previously last selected.

3

While holding down the STORE button,

 

press the REGISTRATION button (1 to 4)

that corresponds to the area where you want to store the setup.

• You can also change the bank selection at this time by pressing the BANK button while holding down the STORE button.

Example: After button 2 is pressed

4 Release the REGISTRATION and STORE

buttons.

Registration memory contents are retained even when you turn off digital piano power (page E-25).

407A-E-021A

E-19