Getting Ready
6. After ensuring that all of the screws are fully tightened, remove the packing material and stand up the stand.
•After standing up the stand, cover each of the eight screws you have installed up to this point with the screw caps G.
7.Attach the brackets M to the pedal unit E and secure them with the screws J.
•Cover the screw heads with the screw caps O.
O
J
J
10. Attach the brackets N to the side panels A and B. Use the two screws H and two joint connectors P to attach each side bracket.
•First, insert the joint connectors P into the side panels. At this time, make sure that the joint connector screw hole is oriented horizontally (openings to the left and right).
•Secure the brackets N with the screws H.
If you have trouble inserting a screw H into the joint connector P screw hole, use a screwdriver to rotate the joint connector ( in Figure).
*CAUTION
•Never try to force the screws! Forcing a screw H to turn while the joint connector P hole is not aligned correctly can strip the screw threads.
Screw hole
E
8.Attach the pedal unit E to the side panels A and B as illustrated below.
•Do not tighten the screws yet.
B
P
N
A
P
B
A
E
9. Secure the back panel D to the back panel C.
•Screw the screws I into the five holes in the back panel D.
C
IX5
D
D
H