Casio QV-7000SX UNPACKING, Lens, Attaching the Strap, Recording, Playback, Connecting the Strap

PRECAUTIONS

PRECAUTIONS

Monitor Screen

Lens

GUIDELINES LAID DOWN BY FCC RULES FOR USE OF

•

Camera performance can be adversely affected by finger-

THIS UNIT IN THE U.S.A. (not applicable to other areas).

Declaration of Conformity

Recording

This device complies with Part 15 of the FCC Rules. Operation is subject

prints or dirt on the lens surface. Never touch the lens sur-

The image shown on the monitor screen during recording is

to the following two conditions: (1) this device may not cause harmful in-

face with your fingers.

terference, and (2) this device must accept any interference received, in-

intended for composition purposes only, so its resolution

• Should the lens become dirty, use a blower to blow off dirt

cluding interference that may cause undesired operation.

Model Number:

QV-7000SX

does not match that of the image as it is recorded. The im-

and dust, or a soft, dry cloth to wipe off the lens.

NOTICE

Trade Name:

CASIO COMPUTER CO.,LTD.

age

is recorded in accordance

with the resolution setting

•

This camera uses a telescoping type lens, which moves

Responsible party:

CASIO INC.

This equipment has been tested and found to comply with the limits for

made

with the procedure under

“Resolution Settings” on

whenever the camera is turned on or off. Make sure noth-

Address:

570 MT. PLEASANT AVENUE,

a Class B peripheral, pursuant to Part 15 of the FCC Rules. These

page 44. Monitor screen refresh speed varies according to

ing is blocking lens movement and never turn power on or

limits are designed to provide reasonable protection against harmful

DOVER,NEW JERSEY 07801

the relative brightness of the subject.

off while the camera is laying lens down.

interference in a residential installation. This equipment generates,

Telephone number:

973-361-5400

•

Never remove batteries or disconnect the AC adaptor while

uses and can radiate radio frequency energy and, if not installed and

Playback

used in accordance with the instructions, may cause harmful interfer-

the lens is

extended. Doing so can cause the lens to be-

ence to radio communications. However, there is no guarantee that

• This camera is designed for high-speed scrolling of images

come stuck

in the extended position, resulting in camera

interference will not occur in a particular installation. If this equipment

This device complies with Part 15 of the FCC Rules.

does cause harmful interference to radio or television reception, which

malfunction.

Operation is subject to the following two conditions:

during playback. Because of this, the playback image that

can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the

(1) This device may not cause harmful interference, and

initially appears on the monitor screen does not show the

following measures:

full resolution of the image as recorded. When you stop at

•

Reorient or relocate the receiving antenna.

(2) this device must accept any interference received, in-

the image you want, the monitor screen refreshes and

•

Increase the separation between the equipment and receiver.

cluding interference that may cause undesired operation.

•

Connect the equipment into an outlet on a circuit different from that

shows the image in its full resolution.

to which the receiver is connected.

• The message “PREVIEW” appears on a TV or CRT screen

•

Consult the dealer or an experienced radio/TV technician for help.

when a preview image is on the screen during output to the

FCC WARNING

VIDEO OUT terminal.

Changes or modifications not expressly approved by the party respon-

CASIO COMPUTER CO.,LTD.

QV-7000SX

• The display area of the image shown on the monitor screen

sible for compliance could void the user's authority to operate the

Tested To Comply

is slightly smaller than the actual full image.

equipment.

Properly shielded cables with ferrite core must be used for connection

With FCC Standards

to host computer and/or peripherals in order to meet FCC emission

limits.

FOR HOME OR OFFICE USE

THE SPECIAL VIDEO CABLE THAT COMES WITH THE CAMERA

----- THE CAMERA TO A VIDEO IN TERMINAL OF A COMPUTER

THE SPECIAL CONNECTION CABLE THAT COMES WITH QV-Link SOFTWARE

----- THE CAMERA TO A PROPER TERMINAL OF A COMPUTER

13

14

UNPACKING			UNPACKING
Check to make sure that all of the items shown below are		Connecting the Strap	Using the Strap as a Wrist Strap	Using the Strap as a Shoulder Strap
included with your camera. If something is missing, contact			Detach the upper strap from the main strap (Figure 1), and	Attach the strap to the camera so the shoulder pad is on the
your dealer as soon as possible.
		Attaching the Strap	then attach the two buckles of the main strap to each other	inside of the loop.
		The two-way strap that comes with the camera can be used	(Figure 2).
			Press the buckles together until they snap securely into
		either as a shoulder strap or a wrist strap. Pass the wrist	place.
		strap through the hole on the side of the camera as shown in
		the illustration.
			upper strap
Camera	2-Way Shoulder/
	Wrist Strap
			(Figure 1)	(Figure 2)
			main strap
	Video cable
Soft case
Manual
		15	16