UNPACKING

Replacing the Wired Remote Controller Battery

The wired remote controller is powered by a single CR2025 lithium battery.

Failure of the wired remote controller to operate probably means that the battery needs to be replaced.

Battery Precautions

• Keep batteries out of the reach of small chil-

1.While pressing the bat- tery holder lock, pull the battery holder from the wired remote con- troller.

Battery holder

Battery holder lock

dren. If swallowed accidentally, contact a phy-

sician immediately.

• Misuse of a battery can cause it to leak, which

damages and corrodes the area around the

battery and creates the danger of fire and per-

sonal injury. Be sure to observe the following

precautions.

• When loading the battery, make sure its posi-

tive (+) and negative (–) sides are facing cor- rectly.

2.After wiping off the two sides of a battery with a soft, dry cloth, place it into the battery holder

with the positive (+) side facing up (so you can see it).

3.Slide the battery holder back into place.

CAUTION

•Use only the battery type that is specified for this unit.

•Never try to charge a battery or take it apart, and never allow its poles to become connected to each other by metal (shorted). Do not ex- pose batteries to heat or dispose of them by burning.

•Dead batteries tend to leak battery fluid. Never leave a dead battery in the wired remote con- troller.

E-22