POWER SUPPLY

•Always be sure to use the AD-C620 AC adap- tor only. Using any other AC adaptor can cause damage to the camera not covered by the war- ranty.

• When unplugging the AC adaptor from the wall

CAUTION socket, be sure to grasp the adaptor (not the cord).

•Avoid any undue bending, pulling, and twisting of the AC adaptor’s cord, and never try to lengthen the cord by splicing it with other wire.

•Be sure to turn power off before connecting or disconnect- ing the adaptor.

•Always turn camera power off before disconnecting the AC adaptor, even if the camera has batteries installed. If you don’t, the camera will turn off automatically when you dis- connect the AC adaptor. You also run the risk of damaging the camera whenever you disconnect the AC adaptor with- out first turning power off.

•The AC adaptor may become warm to the touch after ex- tended periods of use. This is normal and is not cause for alarm.

•After using the camera, turn it off and unplug the adaptor from the AC outlet.

•The camera automatically switches over to AC adaptor powered operation whenever the AC adaptor is plugged into the camera.

•Always use the AC adaptor to power the camera whenever it is connected to a computer.

Power Save Settings

The settings described below let you specify sleep and auto power off trigger times that help to conserve valuable battery power.

SLEEP .................. The monitor screen enters a sleep state

if no operation is performed for a specified amount of time in the Record Mode. Pressing any button restores full power. You can specify 30 seconds, 1 minute, or 2 minutes before the sleep state is triggered, or you can turn off this setting entirely.

AUTO

POWER OFF ........ Auto Power Off turns off camera power if

no operation is performed for a specified amount of time. You can specify 2 min- utes, 5 minutes, or 10 minutes before AUTO POWER OFF is triggered, or you can turn off this setting entirely.

•AUTO POWER OFF takes priority when both SLEEP and AUTO POWER OFF are both set for a 2-minute trigger time. This means camera power turns off if no operation is performed after two minutes.

E-42