SETTING THE CURRENT DATE AND TIME

Use the following procedures to set the current date and time, and to select the date format.

When you record an image, the time and date the image was shot is registered in accordance with data from the camera’s built-in clock. You can even use the TIME STAMP function to “stamp” the date and time inside the image.

IMPORTANT!

•The time and date settings are cleared if the camera is left for about 24 hours without battery and AC power being supplied. If this happens, restore power and make new time and date settings before using the camera again.

•A flashing time display indicates that the time and date (clock) settings have been cleared. Use the procedure on this page to make the correct time and date set- tings.

•If you do not set the camera's built-in clock to the cur- rent date and time, all images are recorded with the default date and time, which probably is not your cor- rect current date and time. Be sure to correctly set the clock before you use the camera.

Setting the Date and Time

1.Press MENU.

2.Select “Set Up” “Date” “Adjust”.

time date

3.Set the current date and time.

•Use [+] and [–] to select the green setting on the moni- tor screen, and then press the shutter to advance to the next setting. Repeat this for all of the settings on the monitor screen.

4.After making all the settings on the monitor screen, press DISP to register them.

E-44