•Button operations are indicated using the letters shown in the illustration.
• The sizes and positions of the characters shown on the sample displays in this manual may differ slightly from those that
35actually appear on the display of your
watch.
•Each section of this manual provides you with the information you need to perform operations in each mode.
•When performing operations with this watch, you must first enter the correct mode (Camera Mode, Timekeeping Mode, etc.) See “GENERAL GUIDE” for information about maneuvering between modes.
•VISUAL DATABANK is a trademark of CASIO COMPUTER CO., LTD.
•CASIO COMPUTER CO., LTD. assumes no responsibility for any loss, or any claims by third parties that may arise through the use of this watch.
BEFORE USING THE WATCH...
Warning!
•Make sure you are in a safe place before operating the watch.
Do not try to record images, perform complex watch operations, or look at the display of the watch while operating an automobile, motorcycle, or any other vehicle. Doing so creates the risk of causing a serious traffic accident. When you use the watch while walking, always keep aware of other people, vehicular traffic, and surface conditions around you in order to prevent accidents.
•Do not use the watch inside of an aircraft.
Never use the watch inside of an aircraft or in any other area where the use of such devices is prohibited. Doing so creates the risk of accident.
•Always back up important data.
Rough handling of or damage to the watch can accidentally delete image data in watch memory. Because of this, you should always keep back up copies of your images on computer disk.
To set the time and date
1.In the Timekeeping Mode, hold down A for about one second until the seconds
FRI 3‰ | digits start to flash on the display. This | |
P | ||
indicates the setting screen. | ||
1‰:58 | ||
• Each press of Dmoves the flashing around |
35the setting screen in the sequence shown
below.
Seconds Hour Minutes Year Month
| Contrast Setting |
|
|
|
| Day | |
|
|
|
|
| |||
|
|
|
|
|
|
|
|
2.While a setting is flashing, use E(+) and
3.When everything is the way you want it, press A to exit the setting screen.
•The watch’s
•The watch automatically exits the setting screen if you do not perform any operation for about two minutes.
•The year can be set in the range of 2000 to 2039.
12-hour/24-hour Timekeeping
Pressing D while the day is flashing on the setting screen causes the indicator for the current timekeeping format (12H or 24H) to flash on the display. Each press of E at this time toggles between
•The timekeeping format you select is applied in all modes.
•With the
•With the
Contrast Adjustment
Pressing of Dwhile the timekeeping format indicator (12H or 24H) is flashing causes the current contrast setting (example: CNT3 = Level 3) to appear on the display, with the level value flashing. Use B(darker) and E(lighter) to adjust the contrast to any one of the seven available levels.
Note
•The contrast setting described above does not affect the display of images. Image contrast can be adjusted using a separate procedure (See “To adjust image contrast”).
Auto Display Off
| The watch automatically turns off its display |
FRI 3‰ | screen if it is not moved for about 60 minutes. |
P | This not only conserves battery power, it also |
1‰:58 | protects against “burn in” of display images. |
35 | To turn the display back on, press F. |
| This displays the Timekeeping Mode screen. |